Mercury 25 Outboard Prop Shaft rebuild

Alancwray

New Member
Hey,

Not sure if this is the correct place, but I am rebuilding a late 80's Merc 25 OB prop shaft assembly. Have 2 questions, 1 how do you get the cross pin into the clutch with no hole to go through? How can you depress the spring and put the pin in at the same time? Also it appears there are a couple of o-rings that are not shown on any schematic of it. Wondering if the 2 it appears I have come from inside the carrier assembly-other wise how would oil not flow down the shaft and out? Thanks!
 
Top