i am going to start the rebuild this week. i got the engine back from the machine shop, it was bored out .020'' to clean up the marks in the cyclinder walls and i got them to press the new pistons on the rods. i have t strip the heads and send them down to be planed but for now i can assemble...
i am going to rebuild my engine this winter. it is in at nova automotive getting bored out .020'' over and i am getting them to install new cam bearings in the block for the new performance marine camshaft. after i get the garage finished i will put the boat in and get to work. anyone else have...
got a phone call this morning and my boat was sunk. flushed out the engine 4 times and got her running and all is ok, put it back in the water and it runs fine.
went boating out in the salt water yesterday and the engine got a ticking noise. i never noticed any performance problems but when i put it back in the lake in the late afternoon the noise changed from a tick to a rattle then it stopped. now i am looking for the parts to change it over to a...
i went to go boating on sunday but my engine was running out of gas at the warf. there was 3/4 of a tank in it so i started looking for problems, the fuel pump did not seem to be sucking so i installed an used electric pump and it still would run out of gas. then i took the boat out of the water...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.